@setchapternewpage

In a book or a manual, text is usually printed on both sides of the paper, chapters start on right-hand pages, and right-hand pages have odd numbers. But in short reports, text often is printed only on one side of the paper. Also in short reports, chapters sometimes do not start on new pages, but are printed on the same page as the end of the preceding chapter, after a small amount of vertical whitespace.

You can use the @setchapternewpage command with various arguments to specify how TeX should start chapters and whether it should typeset pages for printing on one or both sides of the paper (single-sided or double-sided printing).

Write the @setchapternewpage command at the beginning of a line followed by its argument.

For example, you would write the following to cause each chapter to start on a fresh odd-numbered page:

@setchapternewpage odd

You can specify one of three alternatives with the @setchapternewpage command:

@setchapternewpage off

Cause TeX to typeset a new chapter on the same page as the last chapter, after skipping some vertical whitespace. Also, cause TeX to format page headers for single-sided printing. (You can override the headers format with the @headings double command; see section The @headings Command.)

@setchapternewpage on

Cause TeX to start new chapters on new pages and to typeset page headers for single-sided printing. This is the form most often used for short reports. This alternative is the default.

@setchapternewpage odd

Cause TeX to start new chapters on new, odd-numbered pages (right-handed pages) and to typeset for double-sided printing. This is the form most often used for books and manuals.

Texinfo does not have an @setchapternewpage even command.

(You can countermand or modify an @setchapternewpage command with an @headings command. See section The @headings Command.)

At the beginning of a manual or book, pages are not numbered--for example, the title and copyright pages of a book are not numbered. By convention, table of contents pages are numbered with roman numerals and not in sequence with the rest of the document.

Since an Info file does not have pages, the @setchapternewpage command has no effect on it.

Usually, you do not write an @setchapternewpage command for single-sided printing, but accept the default which is to typeset for single-sided printing and to start new chapters on new pages. Usually, you write an @setchapternewpage odd command for double-sided printing.