The commands for manipulating the Calc Trail buffer are two-key sequences beginning with the t prefix.
The t d (calc-trail-display) command turns display of the
trail on and off. Normally the trail display is toggled on if it was off,
off if it was on. With a numeric prefix of zero, this command always
turns the trail off; with a prefix of one, it always turns the trail on.
The other trail-manipulation commands described here automatically turn
the trail on. Note that when the trail is off values are still recorded
there; they are simply not displayed. To set Emacs to turn the trail
off by default, type t d and then save the mode settings with
m m (calc-save-modes).
The t i (calc-trail-in) and t o
(calc-trail-out) commands switch the cursor into and out of the
Calc Trail window. In practice they are rarely used, since the commands
shown below are a more convenient way to move around in the
trail, and they work "by remote control" when the cursor is still
in the Calculator window.
There is a trail pointer which selects some entry of the trail at any given time. The trail pointer looks like a `>' symbol right before the selected number. The following commands operate on the trail pointer in various ways.
The t y (calc-trail-yank) command reads the selected value in
the trail and pushes it onto the Calculator stack. It allows you to
re-use any previously computed value without retyping. With a numeric
prefix argument n, it yanks the value n lines above the current
trail pointer.
The t < (calc-trail-scroll-left) and t >
(calc-trail-scroll-right) commands horizontally scroll the trail
window left or right by one half of its width.
The t n (calc-trail-next) and t p
(calc-trail-previous) commands move the trail pointer down or up
one line. The t f (calc-trail-forward) and t b
(calc-trail-backward) commands move the trail pointer down or up
one screenful at a time. All of these commands accept numeric prefix
arguments to move several lines or screenfuls at a time.
The t [ (calc-trail-first) and t ]
(calc-trail-last) commands move the trail pointer to the first or
last line of the trail. The t h (calc-trail-here) command
moves the trail pointer to the cursor position; unlike the other trail
commands, t h works only when Calc Trail is the selected window.
The t m (calc-trail-marker) command allows you to enter a
line of text of your own choosing into the trail. The text is inserted
after the line containing the trail pointer; this usually means it is
added to the end of the trail. Trail markers are useful mainly as the
targets for later incremental searches in the trail.
The t k (calc-trail-kill) command removes the selected line
from the trail. The line is saved in the Emacs kill ring suitable for
yanking into another buffer, but it is not easy to yank the text back
into the trail buffer. With a numeric prefix argument, this command
kills the n lines below or above the selected one.
The t . (calc-full-trail-vectors) command is described
elsewhere; see section Vector and Matrix Display Formats.