This section describes the various notations that are used throughout the Calc manual.

In keystroke sequences, uppercase letters mean you must hold down
the shift key while typing the letter. Keys pressed with Control
held down are shown as `C-x`. Keys pressed with Meta held down
are shown as `M-x`. Other notations are `RET` for the
Return key, `SPC` for the space bar, `TAB` for the Tab key,
`DEL` for the Delete key, and `LFD` for the Line-Feed key.

(If you don't have the `LFD` or `TAB` keys on your keyboard,
the `C-j` and `C-i` keys are equivalent to them, respectively.
If you don't have a Meta key, look for Alt or Extend Char. You can
also press `ESC` or `C-[` first to get the same effect, so
that `M-x`, `ESC x`, and `C-[ x` are all equivalent.)

Sometimes the `RET` key is not shown when it is "obvious"
that you must press `RET` to proceed. For example, the `RET`
is usually omitted in key sequences like `M-x calc-keypad RET`.

Commands are generally shown like this: `p` (`calc-precision`

)
or `M-# k` (`calc-keypad`

). This means that the command is
normally used by pressing the `p` key or `M-# k` key sequence,
but it also has the full-name equivalent shown, e.g., `M-x calc-precision`.

Commands that correspond to functions in algebraic notation
are written: `C` (`calc-cos`

) [`cos`

]. This means
the `C` key is equivalent to `M-x calc-cos`, and that
the corresponding function in an algebraic-style formula would
be ``cos( x)'`.

A few commands don't have key equivalents: `calc-sincos`

[`sincos`

].

Go to the first, previous, next, last section, table of contents.